SITE MAP
서브 비주얼
Thank you for visiting ATS
ADVANCED TECHNOLOGY SOLUTION
컨텐츠
O-ring installation
External O-ring
External O-ring Installation M/C(ASP-1)
- Product Features
- Now there is a faster, more accurate way to install O-Rings onto components and assemblies. With the ASP-1, O-Rings are fed from a vibratory feeder bowl, down a feedtrack, and onto an installation mandrel.
(For O-Rings larger than 1.156" O.D. see ASP-2 literature). An operator places the component into the mandrel and, with a light push, automatically installs the O-Ring.
- Product Information
Features
• Compact, Benchtop Mounted Machine (Less than 4 Square Feet)
• Cycle Rates Up to 60 Times per minute (Over 3,600 per hour)
• Digital and Resetable Counter
• Right-hand or Left-hand Configuration
• Simple Tooling Head Change(Less than 10 minutes)
• Can Be Automated for Horizontal or Vertical Applications
• Accommodates O-Rings Ranging From 0.150” (3.810mm) to 1.156”** (29.362mm) Outside Diameter*
*Dependent upon ratio of cross section to outside diameter and O-Ring material.
** For applications with O-Rings larger than 1.156" O.D., see our ASP-2 machine.
Specifications
• 115 VAC, 60 Hz. (Other voltages available onrequest.)
• 90 psi (6.205 bar) air supply.
Applications
• O-Rings
• Back-Up Rings
• Cup Rings
• Quad Rings
• Split Seals
• Teflon® Seals
Options
• Low Lube Reservoir Sensor - Shuts down the ASP-1 when lubricant reservoir needs refilling.
• O-Ring Detection - A sensor checks for the presence of an O-Ring on the mandrel with each cycle of the machine. If an O-Ring is not present, a warning light will be turned on and the machine will shut down.
• O.D. Lubricator - Applies lubrication to the outside diameter of the O-Ring.
• Stainless Steel - Available for “clean room” applications.
