Complete marking unit for integration

• Pneumatic Scribe Marking Head in two window sizes

• Model 200 I-Mark Controller

• I-Mark software for programming

• Power cable, Marking head cable, Cross over cable, and LAN cable

I-Mark-IS Marking Head

• Air and controller connection located on back of marker.

• Solid aluminum frame with ½” plates on three sides for easier mounting, all 3 pre-drilled & tapped.

• High torque stepper motors and ball screw drives for precise positioning.

• Pneumatic pin with diamond tip to mark hard parts 45 - 65 Rc

• Mountable in any orientation

I-Mark Model 200 controller

• Compact design for easy installation into production equipment.

• Communication options including remote programming over LAN, and operational controls via I/O, Modbus, Serial, Ethernet IP ect.

• Touch screen/monitor upgrade

Options

• Pedestal mount

• Upgrades: database and camera integration

Features

• High torque stepper motors with ball screw drive

• 2D and Square-Dot® capable

• 2 marking windows:

  -Medium = 1.59” x 2.35” (40 x 60mm)

  -Large = 3.18” x 7.87” (80mm x 200mm)

• Marking speed of 4-5 (1/8”, 3mm) cps

• 10 ft (3m) or 25 ft (7.5m) cable from head to controller

• Diamond pin included – Marks hard and carbide metals (up to 65 RC)

• Weight of marking head assembly: 19lbs

Utilities

• Controller requires 110 VAC power, 6 ft (1.8m) electrical cord supplied

• Air power required, 8mm push-in tube fitting requires connection to air supply (30-75 PSI operating range)